Skip to main content

Manual lift tower editing

Problem: Towers are placed automatically and can’t be changed. Sometimes one lands in the middle of a trail, or the cable runs too low over a change in slope, and the only fix is rebuilding the whole lift.

Request: A tower edit mode for existing lifts:

  • Move, add or remove towers along the line.

  • Adjust tower height to clear trails, roads or other lifts.

  • Show cable clearance and warn when the cable is too low.

  • Auto-placement stays the default, so editing is optional.

  • Tower padding prop around towers on or near trails, either cosmetic or with a small safety bonus.

Log in to comment and vote

No comments yet

Be the first to share your thoughts.